REFERENCE NUMBER: 29029

SPECIFICATIONS:
Reference #: 29029
Model Number: W-15/W-20
Serial Number: Y-3045-385
Hand of Operation: Left to Right

Catalog Capacity: W-15 – 1-1/2″ Diameter x .083″ Max. Wall
Carbon Steel – .375″ Min. Diameter
Catalog Capacity: W-20 – 3″ Diameter x .120″ Max. Wall
Carbon Steel – .500″ Min. Diameter

Note: With special tooling, this tube mill will make 3-1/2″ diameter or larger.

EQUIPMENT SUMMARY

Single End Uncoiler:
Manufactured by Cooper Weymouth-Peterson
Model Number: 4R-18
Serial Number: 19613
Capacity: 8,000 Lbs.
Coil Width: 15″ Maximum
Electric Brake
1 H.P. Feed Up Motor
1 Set of Coil Keepers

Forming Mill:
Model W-20 (2 Sets of Rafted Stands; 1 Set is Mounted on the Mill Bases)
Pass Arrangement:
1 – Entry Guide Stand
4 – Driven (Lower Shaft Only) Breakdown Stands; 2″Shafts
3 – Driven Fin Stands; 2″ Shafts
7 – Idle Sideroll Stands
Note: All driven stands are driven by 40:1 cone drive gearbox through universal drive shaft with quick disconnect feature.

Weld Section:
1 – Olympia V.T. (Italy) Weld Unit with Cyclomatic Magnetic Arc Control
1 – Torch 4-Roll (2 Sets Mounted in Tandem) Enclosed in an Atmospheric Weld Station
Powered by Miller Syncrowave 350 A.C./D.C. Welder
Weld Condition Monitor; Manufactured by Pruf Technik; Model LAB 2004

2-Roll Ironing Stand:
With Mandrel Bracket and Mandrel Mounted Upstream

Stainless Steel Cooling Trough:

Sizing Mill:
Model W-20 (2 Sets of Rafted Stands; 1 Set is Mounted on the Mill Bases)
Pass Arrangement:
3 – Driven Sizing Stands; 2″Shafts
3 – Idle Sideroll Stands
1 – 4-Roll Straightening Turkshead

Mill Drive:
2 – Reliance Drives
2 – Model D.C. Integrators Model 590 Plus
2 – 7.5 H.P. D.C. Motors
Complete with Operator’s Bench and Saw Operator’s Bench and Transformers.

Cut-Off Saw:
Abrasive Saw
Entry & Exit Clamping (Hydraulic)
4′ Travel by Hydraulic Cylinder
Everet Saw Head Model 26; Serial Number 945-8; Mounted on Thompson Shafting
30 H.P. A.C. Motor; 1750 RPM
26″ Diameter Abrasive Blade
Hydraulic Downfeed

20′ Run-Out Table:

Tooling: Some tooling is included, but not inventoried.

Large amount of technical manuals and drawings.

Note: Also included is a complete set of Model W-15 rafted stands with 1-1/2″ shafts and idle sideroll stands with the same pass arrangement described above that also connect to the cone drive gearboxes through universal drive shafts.

Print this post


Click on image to enlarge


Click on photo to appear in center